Ethernet Debug Commands

<ch-name> : enet0, enet1

ether config     display Ethernet dirver configuration information
ether driver cnt disp <ch-name> display ether driver counters
ether driver cnt clear <ch-name> ch-name: enet0, enet1
ether driver iface    
ether driver init <ch-name>  
ether driver ioctl <ch-name> <command> [arguments]  
ether driver mac <mac address>  
ether driver reg <ch-name> display LAN hardware related registers
ether driver rxmod <mode> set LAN receive mode. 
mode:
1: turn off receiving
2: receive only packets of this interface
3: mode 2+ broadcast
5: mode 2 + multicast
6: all packets
ether driver status <ch-name> ch-name: enet0, enet1
ether edit accessblock <0:disable|1:enable>  
ether edit load <ether no(1:lan).>  
ether edit mtu <value>  
ether edit save    
ether mac   <src ch> <des ch> <ip>  
ether pkttest arp [ip-addr]  
ether pkttest disp event [ch] [on|off]  
ether pkttest disp packet [0|1|2]  
ether pkttest mem <addr> <data> [type]  
ether pkttest sap    
ether pncconfig      
ether test      
ether version